IBM xSeries 240 81Y Hardware Maintenance Manual page 147

1
Flange
2
Server door
a. Set the door 2 on the bottom hinge.
b. Press the flange 1 downward while pressing
the top of the door toward the server, until the
flange connects with the top hinge. Release the
flange.
6. Close and lock the server door.
Attention
Be sure to maintain a clearance of at least
127 mm (5 inches) on the front and rear of the
server to allow for air circulation.
7. If you disconnected any cables from the back of the
server, reconnect the cables; then, plug the power
cords into properly grounded electrical outlets.
Note
If necessary, see "Input/output connectors and
expansion slots" on page 87 for connector
locations.
139
xSeries 240