Scsi Disk Utilities - IBM xSeries 240 81Y Hardware Maintenance Manual

This menu has the following choices:
Host Adapter SCSI ID
The assigned SCSI ID of the SCSI controller is 7.
SCSI Parity Checking
The assigned value is Enabled.
Host Adapter SCSI Termination
The assigned value is Automatic.
Boot Device Options
Select this choice to configure startable device
parameters. Before you can make updates, you must
know the ID of the device whose parameters you
want to configure.
SCSI Device Configuration
Select this choice to configure SCSI device
parameters. Before you can make updates, you must
know the ID of the device whose parameters you
want to configure.
Note
When the Maximum Sync Transfer Rate is set
to 40.0, this value represents the transfer rate for
UltraSCSI devices. When the Maximum Sync
Transfer Rate is set to 80.0, this value
represents the transfer rate for Ultra2 SCSI LVD
devices. When the Maximum Sync Transfer
Rate is set to 20.0, this value represents the
transfer rate for Fast SCSI devices.
Advanced Configuration Options
Select this choice to view or change the settings for
advanced configuration options. These options
include enabling support for large hard disk drives
and support for drives with UltraSCSI speed.
To reset the SCSI controller defaults, press F6; then,
follow the directions on the screen.

SCSI Disk Utilities:

To see the IDs that are assigned
to each SCSI device or to format a SCSI device, select
SCSI Disk Utilities from the SCSISelect Utility menu.
To use the utility program, select a drive from the list.
Read the screens carefully before making a selection.
Note
If the following screen appears, you might have
pressed Ctrl+A before the selected drives were ready.
Restart the server and watch the SCSISelect
messages as each drive spins up. After the drive that
you want to view or format spins up, press Ctrl+A.
39
xSeries 240