Tower-To-Rack Conversion Kit; Inventory List; What You Will Need - IBM xSeries 240 81Y Hardware Maintenance Manual

Tower-to-Rack Conversion Kit

With the IBM xSeries 240 Tower-to-Rack Conversion Kit,
you can convert your server from a tower model to a rack
model. This book provides instructions for installing a
conversion kit on your server and installing your server in a
rack enclosure. For additional information about the
xSeries 240 server, consult the "Hardware Information"
section of the xSeries 240 Server Library.
Note
Installing the server in a rack will require three people.

Inventory list:

The conversion kit contains the
following items:
Two chassis brackets
Two server covers
One service label
One rack-model trim bezel, with power-on switch
protector attached in a bag
Two wheel-shaped knobs
One or more packages of screws, some of which are
optional replacement screws
One installation template
One rack mounting kit
– Two slide-rail assemblies
– One cable-management arm assembly including
hitch pins
– One bag of screws and nuts
– Hook and loop fastener strips
– One packet of tiewraps
IBM xSeries 240 Tower-To-Rack Conversion Kit
Installation Instructions (this book)
IBM xSeries 240 Hot-Plug SCSI Setup Utility diskette

What you will need:

You will need the following
items to install the conversion kit and to install the server
in a rack:
Flat-blade screwdriver
The documentation that comes with the rack
169
xSeries 240