Installing A Non-Hot-Swap Drive - IBM xSeries 240 81Y Hardware Maintenance Manual

3. To install the drive, go to "Installing a non-hot-swap
drive" on page 124 or "Installing a drive in a hot-swap
bay" on page 125.

Installing a non-hot-swap drive

Before you begin:
Read "Safety information" on page 224.
Read the documentation that comes with the
drive.
Prepare the drive for installation (see
"Preinstallation steps (all bays)" on page 123).
Note
The server's EMI integrity and cooling are both
protected by having the non-hot-swap bays covered or
occupied. When you install a drive, save the filler
panel from the bay, in case you later remove the drive
and do not replace it with another.
Refer to the following illustration of the tower model while
you perform the steps in this procedure.
1
DLT drive
2
Filler panel
3
Blue slide rails
4
Metal slide rails
To install a non-hot-swap drive in one of the
non-hot-swap bays:
1. Turn off the server and peripheral devices (see
"Preparing to install options" on page 96) and then
remove the cover. See "Removing the left-side cover
(tower model)" on page 99 or "Removing the cover
(rack model)" on page 100.
124
xSeries 240 HMM