IBM xSeries 240 81Y Hardware Maintenance Manual page 184

c. From inside the server, gently pull the cable
toward the rear of the server until the cable is
free of the non-hot-swap bay area.
d. Release the cable from the cable clip on the
right side of the server, behind the non-hot-swap
bays.
e. Reroute the cable to the top left side of the
server.
1) Run the cable along the top of the hard disk
drive (HDD) backplane assembly toward the
left side of the server 1 , tucking the cable
under the two protrusions at the rear of the
HDD backplane assembly as you do so.
Note
The HDD backplane assembly is at the
immediate rear of the fan platform.
2) Make sure to tuck the cable between the
server left side and the HDD backplane
support 2 ; then, continue along the
server left side to the server left front
corner.
f. Reattach the cable to the operator LED panel.
Note
If you have difficulty connecting the cable,
turn the cable connector over and try again;
the cable connector is keyed to connect only
one way.
g. Move the operator LED panel and bracket to the
inside of the server, in its new location.
176
xSeries 240 HMM