Installing A Hard Disk Drive; Installing A Non-Hot-Swap Hard Disk Drive In Bay 5, 6, Or 7 - IBM eserver xSeries 220 Type 8648 Installation Manual

12. If you have other options to install or remove, do so now; otherwise, replace the

Installing a hard disk drive

Refer to the following sections to install a hard disk drive.
Attention:
•
•
Notes:
1. The illustrations in this document might differ slightly from your hardware.
2. If your server has a redundant array of independent disks (RAID) adapter

Installing a non-hot-swap hard disk drive in bay 5, 6, or 7

Note: You can also install a non-hot-swap hard disk drive in bay 4. See "Installing a
To install a non-hot-swap hard disk drive in bay 5, 6, or 7, do the following:
1. Read the information in "Preinstallation steps (all bays)" on page 20.
22
xSeries 220: Installation Guide
cover (see "Installing the cover" on page 29 for details).
When you handle static-sensitive devices, take precautions to avoid damage from
static electricity. For details on handling these devices, see "Handling static-
sensitive devices" on page 3.
To maintain proper system cooling, do not operate the server for more than 2
minutes without either a drive or a filler panel installed in each bay.
installed, refer to the information provided with the RAID adapter for information
about configuring a drive.
Locking tab
drive in bay 1, 2, 3, or 4" on page 20 for instructions.