Installing A Non-Hot-Swap Drive - IBM xSeries 150 User Reference Manual

Installing a non-hot-swap drive

Notes:
To install a non-hot-swap drive (5.25-inch, removable media) in one of the non-hot-
swap bays:
38
IBM® xSeries 150 : User's Reference
1. The server's electromagnetic interference (EMI) integrity and cooling are both
protected by having the non-hot-swap bays covered or occupied. When you
install a drive, save the filler panel from the bay, in case you later remove the
drive and do not replace it with another.
2. The illustrations in this document might differ slightly from your hardware.
Blue slide rails
1. Read the information in "Preinstallation steps (all bays)" on page 35.
2. Turn off the server and peripheral devices and then remove the cover and the
bezel (see "Removing the cover, door, and bezel" on page 26 for details).
3. Remove the filler panel from the bay opening by pulling the filler panel away
from the server. You do not need the filler panel when you have a drive installed
in the bay.
4. If the drive is a laser product, observe the following safety precaution:
Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters)
are installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could result in
exposure to hazardous laser radiation. There are no serviceable parts inside the
device.
• Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
Filler panel
Non-hot-swap bay
Non-hot-swap drive
Slide rails