Attaching The Stacker To A W360 Tabber - Pitney Bowes W985 User Manual

Attaching the Stacker to a W360 Tabber

The Stacker can be used at the output end of the W360 Tabber to collect the tabbed pieces as they
come off the Tabber. NOTE: The Stacker is mounted inline with the Tabber, unlike the right angle used
for the printers.
1. Move Stacker into position so it is inline with the Tabber output end (see figure below). Hold the
Stacker steady with upright pressure and loosen the height adjustment knob. Set the height so
the Stacker is even with output of the Tabber and tighten the adjustment knob.
1. Tabber
2. Stacker
3. Stacker Height Adjustment Knob
Pitney Bowes User Guide September 2021
Attachment of Stacker to a W360 Tabber
52