Adjust "Stack Full" Sensor - Pitney Bowes W985 User Manual

Adjust "Stack Full" Sensor

Operation
There are two adjustments on the "stack full" sensor: setting the vertical position and the horizontal
position.
To adjust the vertical position:
Loosen the vertical position knob on the operator side of the sensor assembly. Move the sensor
l
assembly to the desired value on the vertical scale. Tighten the knob when finished.
To adjust the horizontal position:
Loosen the horizontal position knob on the operator side of the sensor assembly. Move the
l
sensor assembly to the desired value on the horizontal scale. Tighten the knob when finished.
1. "Stack Full" Sensor
2. Horizontal Adjustment Knob
3. Horizontal Position Scale
4. Vertical Adjustment Knob
5. Vertical Position Scale
The stacker full sensor should remain at the "0" position in both height (vertical) and length (horizontal)
settings for most material. However, you may need to change these settings for certain conditions:
Pitney Bowes User Guide September 2021
Stacker Adjustments
26