Adjust Input Media Stop - Pitney Bowes W985 User Manual

Stacker Adjustments

Adjust Input Media Stop

Operation
There are two adjustments on the input media stop: height and depth.
To adjust the height:
Loosen the knob on the side of the input media stop and slide the plate up or down. For 1/16"
l
(1.6mm) thickness, slide a sample mail piece under the balls and lower the media stop to the
point of contact and then lock. For over 1/16" (1.6mm) thickness, set the media stop low enough
so that mail piece cannot get below the edge of the media stop and then lock.
To adjust the depth:
There is a scale on the input media stop that is used to set up for different size mail pieces.
l
Loosen the two knobs and set the knobs to the desired value on the scale. Tighten the knobs
when you are finished.
Pitney Bowes User Guide September 2021 23