Canopy Hatch Installation - Casablanca Verrazano Owner's Manual

Casablanca verrazano ceiling fans: owners manual

Hide thumbs Also See for Verrazano:

Instructions manual (15 pages)

Table Of Contents

Table of Contents

Step 6b. The W-18 / W-28 is designed to replace a standard

wall switch and will fit wall boxes (metal or plastic) with

a depth of 2" or greater.

CAUTION: Ensure power is turned OFF

at the breaker or fuse panel before

starting installation.

1. Remove the screws and switch plate from the existing

switch box.

2. Remove the screws holding the switch in the switch box.

3. Pull the existing switch from the switch box to expose

the wire connections.

4. Remove the three wires from the switch.

5. Wiring preparation, if required:

Strip wires:

• 3/8" for 14 guage

• 1/2" for 16 and 18 guage

NOTE: The wire connectors provided are suitable for copper

wire only. Use to join the following wire combinations:

One No. 14 guage with one No. 16 or 18 guage

6. Connect black lead of control to 120V AC hot wire. Connect

the red lead to the light circuit controlled by slider on

right side of unit. Connect yellow lead to fan motor(s)

wire. The fan speed will be controlled by the left slider

on the unit. If unit is used to control only one light

circuit, place wire connector on unused lead. Secure these

connections with the wire connectors.

Step 7. Tuck the wires into the canopy

with the wire nuts pointed upwards, so

that the WHITE and BLACK wires are on

opposite sides of the canopy and all wires

are clear of the canopy opening.

Step 8. Install canopy hatch with the

last canopy screw and lock washer. To do

this, tilt the fan body away from the hatch

opening. Tighten the screws firmly by

hand only.

Step 9. Straighten the fan, then check

to ensure that there is no movement be-

tween the canopy and ceiling or Hang-Tru

ball and top support shaft.

INSTALLATION OF WALL CONTROL

3/8" or 1/2"