Canopy Hatch Installation - Casablanca AURORA Owner's Manual

A
URORA
Step 5. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 6. Install canopy hatch with the last
canopy screw and lock washer. To do this,
tilt the fan body away from the hatch
opening.
Tighten the screws firmly by hand only,
Step 7. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.
INSTALLING THE BLADE/BLADE HOLDER TO FAN MOTOR
Step 8. To reach the blade holder mounting
holes in the fan motor the switch housing
mount must be temporarily removed.
Take out the three 5-32 X
screws securing the switch housing mount
and remove. Put the three (3) screws and
mount aside for the moment, they will be
replaced in Step 11 after the blades are in-
stalled.
Note: Versa•Touch models
will have only a wire nut
capping the black and
white wires coming out of
the fan motor.
BLADE TO BLADE HOLDER INSTALLATION
BLADE SCREW
(4 PER BLADE)
STEEL WASHER
(4 PER BLADE)
6
™

CANOPY HATCH INSTALLATION

Note: Write down the
Serial Number and the
model number for future
reference.
PREPARATION
9
/ " shoulder
32
BLADE & BLADE HOLDER HARDWARE
CANOPY
HATCH
LOCK
WASHER
CANOPY
SCREW
SWITCH HOUSING MOUNT
SHOULDER SCREW
5-32 X 9 / " (3)
32
BLADE
HOLDER
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW
SWITCH
HOUSING
MOUNT
BLADE HOLDER
SCREW
(2 PER BLADE)