Table of Contents
Advertisement
Step 5a. To hang the fan body in the canopy, hold
the fan body firmly and insert the ball into the canopy
opening. Check that no wires are pinched. Rotate
the fan body until the slot in the ball fits into the pin
opposite the canopy opening.
Step 5b. Trim excess motor wires, leaving at least
6 inches above the downrod. Strip ½-inch insulation
from the end of each wire using a wire stripper
(available at your local hardware store).
CANOPY ELECTRICAL CONNECTIONS
Step 6. Attach the fan wires to the ceiling fixture outlet
box wiring by placing the bare ends of the wires side
by side and then securing with a wire nut. Test that
the connection is secure by pulling on the wire nut.
Connect in this order:
• GREEN leads from mounting plate and downrod
assembly of fan to GROUND conductor of power
source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire
in ceiling outlet box. Secure with wire nut.
• BLUE D1-OPTION wire from fan to RED power
wire (second hot wire) in ceiling outlet box. Secure
with wire nut.
After making the wire connections, the wires should
be spread apart with the grounded conductor and
the equipment-grounding conductor on one side of
the outlet box and the ungrounded conductor on the
other side of the box. The splices after being made
should be turned upward and pushed carefully into
the outlet box.
Step 7a. Tuck the wires into the canopy with the wire
nuts pointed upwards, so that the WHITE and BLACK
wires are on opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 7b. Install the canopy hatch with the last
canopy screw and lock washer using the provided
screwdriver. To do this, tilt the fan body away from
the hatch opening. Tighten the screws firmly.
Step 7c. Straighten the fan, then check to ensure that
there is no movement between the canopy and the
ceiling or the downrod and the ball assembly.
HANGING THE FAN
CANOPY HATCH INSTALLATION
Heritage II
TM
BALL
SLOT
WIRE NUT
RED AND BLUE
WIRES
2 BLACK WIRES
2 WHITE WIRES
3 GREEN WIRES
NOTE: If the color of your ceiling wires differs from that
described, consult an electrician.
CANOPY
HATCH
CANOPY
SCREW &
WASHER
PIN
CANOPY
11
Advertisement
Table of Contents
