Ceiling Hardware; Adaptor Plate Installation - Casablanca Verrazano Owner's Manual

V
ERRAZANO
CROSSBAR
MOUNTING
BRACKET
Note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2" x 4" stud must be installed.
Step 1. Remove the knockout plug in the center of the outlet
1
box or drill a hole for the lag screw to pass through. Then
/
2
1
drill a guide hole into the joist or beam to a depth of 3 .
/
4
Step 2. Route the outlet box wires through the keyhole slot
of the crossbar mounting bracket as shown. Attach the cross-
bar mounting bracket to outlet box with screws provided,
assuring that the outlet box wires are not pinched by the
washer.
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with
the approved outlet box to install the crossbar
mounting bracket.
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE ONLY.
4
™

CEILING HARDWARE

WIRE NUT (4)
SUPPORT INSTALLATION PARTS
LAG SCREW
/ " #7 X 5" (1)
3
8

ADAPTOR PLATE INSTALLATION

ADDITIONAL HARDWARE
1" x 8-32 ROUNDED
HEAD SCREW (2)
JOIST
CEILING FAN
APPROVED
WIRING BOX
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
APPROVED
OUTLET BOX
HARDWARE
2 1 " x 8-32 ROUNDED
/
4
HEAD SCREW (2)
FLAT WASHER (2)
LARGE
FLAT WASHER
/ " (1)
3
8
CEILING
WIRING
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE