Hanging The Fan; Canopy Electrical Connections; Canopy Hatch Installation - Casablanca Trident Owner's Manual

Step 6a. to hang the fan body in the canopy, hold the fan
body firmly and insert the ball into the canopy opening.
Check that no wires are pinched. Rotate the fan body until
the slot in the ball fits into the pin opposite the canopy
opening.
Step 6b. trim excess motor wires, leaving at least 6 inches
above the downrod. Strip /
1
2
of each wire using a wire stripper (available at your local
hardware store). The splices after being made should be
turned upward and pushed carefully into the outlet box.

canopY elecTRIcal connecTIonS

Step 7. attach the fan wires to the ceiling fixture outlet box
wiring by placing the bare ends of the wires side by side and
then securing with a wire nut. test that the connection is
secure by pulling on the wire nut. Connect in this order:
• GREEn leads from mounting plate and downrod
assembly of fan to GRound conductor of power
source. Secure with wire nut.
• WHITE wire from fan to white nEUTRAl wire in
ceiling fixture outlet box. Secure with wire nut.
• BlACK power wire from fan to BlACK power wire in
ceiling outlet box. Secure with wire nut.
after making the wire connections, the wires should
be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the outlet
box and the ungrounded conductor on the other side of
the outlet box.
notE: if the color of your ceiling wires differs from that
described, consult an electrician.
Step 8a. tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BlACK wires are
on opposite sides of the canopy and all
wires are clear of the canopy opening.
Step 8b. install the canopy hatch with the
last canopy screw and lock washer using
the provided screwdriver. to do this, tilt
the fan body away from the hatch opening.
tighten the screws firmly.
8

hanGInG The Fan

-inch insulation from the end

canopY haTch InSTallaTIon

Ball
Slot
wire nut
2 Black wires
2 white wires
3 Green wires
canopy hatch
canopy washer
canopy Screw
Tilt the fan to install last
canopy screw
pin