Canopy Electrical Connections; Canopy Hatch Installation - Casablanca Metropolitan Owner's Manual

Step 3. To hang the fan body in the
canopy, hold the fan body firmly and
insert the nylon ball into the canopy
opening. Check that no wires were
pinched. Rotate the fan body until the
slot in the nylon ball fits into the pin
opposite the canopy opening.
Note: Fan weighs 25lbs.

CAnopy ElECTRICAl ConnECTIonS

Step 4. Attach the fan wires to the ceiling fixture outlet
box wiring by twisting the bare ends of the wires together
and then securing with a wire nut. Test that the connec-
tion is secure by pulling on the wire nut. Connect in this
order:
electrical Connections
• gReeN leads from mounting plate and fan to
gROuNd conductor of power source. Secure
with wire nut.
• WHITe wire from fan to white NeuTRAL wire in
ceiling fixture outlet box. Secure with wire nut.
• bLACK power wire from fan to bLACK power wire
in ceiling outlet box. Secure with wire nut.
Step 5. Tuck the wires into the canopy
with the wire nuts pointed upwards,
so that the WHITe and bLACK wires
are on opposite sides of the canopy
and all wires are clear of the canopy
opening.
Step 6. Install canopy hatch with the
last canopy screw and lock washer.
To do this, tilt the fan body away from
the hatch opening.
Tighten the screws firmly by hand
only,
Step 7. Straighten the fan, then check
to ensure that there is no movement
between the canopy and ceiling or
Hang-Tru ball and top support shaft.
BAll

CAnopy hATCh InSTAllATIon

Note: Write down the
Serial Number and
the model number for
future reference.
M
etropolitan
SloT
2 bLACK WIReS
2 WHITe WIReS
3 gReeN
wIRES
wIRE nUT
CAnopy
hATCh
loCK
wAShER
CAnopy
SCREw
®
pIn
TIlT ThE
fAn To
InSTAll
lAST
CAnopy
SCREw
5