Hanging The Fan; Canopy Electrical Connections; Canopy Hatch Installation - Casablanca WHITMAN Owner's Manual

Step 7a. To hang the fan body in the canopy, hold
the fan body fi rmly and insert the ball into the canopy
opening. Check that no wires are pinched. Rotate
the fan body until the slot in the ball fi ts into the pin
opposite the canopy opening.
Step 7b. Trim excess motor wires, leaving at least
6 inches above the downrod. Strip
from the end of each wire using a wire stripper
(available at your local hardware store).

CANOPY ELECTRICAL CONNECTIONS

Step 8. Attach the fan wires to the ceiling fi xture outlet
box wiring by placing the bare ends of the wires side
by side and then securing with a wire nut. Test that
the connection is secure by pulling on the wire nut.
Connect in this order:
• GREEN leads from mounting plate and downrod
assembly of fan to GROUND conductor of power
source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in
ceiling fi xture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire
in ceiling outlet box. Secure with wire nut.
After making the wire connections, the wires should
be spread apart with the grounded conductor and
the equipment-grounding conductor on one side of
the outlet box and the ungrounded conductor on the
other side of the box. The splices after being made
should be turned upward and pushed carefully into
the outlet box.
NOTE: If the color of your ceiling wires differs from
that described, consult an electrician.
Step 9a. Tuck the wires into the canopy with the wire
nuts pointed upwards, so that the WHITE and BLACK
wires are on opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 9b. Install the canopy hatch with the last
canopy screw and lock washer using the provided
screwdriver. To do this, tilt the fan body away from
the hatch opening. Tighten the screws fi rmly.
Step 9c. Straighten the fan, then check to ensure
that there is no movement between the canopy and
the ceiling or the Perma•Lock
assembly.
8

HANGING THE FAN

1 / -inch insulation
2

CANOPY HATCH INSTALLATION

™
downrod and the ball
BALL
SLOT
WIRE NUT
2 BLACK WIRES
2 WHITE WIRES
3 GREEN WIRES
CANOPY
HATCH
CANOPY
SCREW &
WASHER
PIN
CANOPY