Preparation Instructions; Fan Preparation - Casablanca Verrazano Owner's Manual

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
Carton Contents
The fan carton contains the fan body, warranty card, owner's
manual, and all the parts necessary to assemble and install your
Casablanca ceiling fan. These parts are shown at the start of
each installation section. Before you start, go through this
Owner's Manual and confirm that you have all the parts shown
in each section.
ALLEN SET SCREW
1 ⁄ -20 x 1 ⁄ "
4 4
(PRE-INSTALLED)
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN,
INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma • Lock™ downrod and ball assembly, keeping the wires
to one side of the cross pin.
NOTE: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using the provided allen wrench, loosen the allen set
screw. Thread the downrod into the motor coupling until it
stops turning, this will take at least four and a half full turns.
Step C. Securely tighten the allen set screw with the provided
allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the locking
bolt may cause the fan to fall during nor-
mal operation!
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
V

PREPARATION INSTRUCTIONS

GETTING STARTED
PERMA • LOCK™ HARDWARE
3mm
ALLEN WRENCH

FAN PREPARATION

LOCK THE ASSEMBLY
GETTING STARTED
ERRAZANO
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 4 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap,
be careful not to scratch the blades.
DOWNROD & BALL
ASSEMBLY
MOTOR
WIRES
TAPERED
THREAD
ALLEN SET
SCREW
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked 'Approved for ceiling fan mounting' . If it is not, a new
box must be installed.
NOTE: The fan weight is 37.5 pounds.
™
GROUND
WIRE
DOWNROD
&
BALL
ASSEMBLY
MOTOR
COUPLING
REVERSE
SWITCH
3