Ceiling Hardware; Crossbar Mounting Bracket Installation - Casablanca Stealth Instructions Manual

CROSSBAR
MOUNTING
BRACkET

CROSSBAR MOUNTING BRACkET INSTALLATION

Note: after removing the old fixture, check the outlet
box to insure that it is supported by a joist or beam
across its upper surface. If not, a 2" x 4" stud must
be installed.
Step 1. Remove the knockout plug in the center of the
outlet box or drill a " hole for the lag screw to pass
1
/
2
through. Then drill a " guide hole into the joist or beam
1
/
4
to a depth of 3".
Step 2. Route the outlet box wires through the keyhole
slot of the crossbar mounting bracket as shown. Attach the
crossbar mounting bracket to outlet box with screws pro-
vided, assuring that the outlet box wires are not pinched
by the washer.
CAUTION: To reduce the risk of personal
injury, use only the mounting hardware pro-
vided with the approved outlet box to install
the crossbar mounting bracket.
wARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE
4

CEILING HARDwARE

wIRE NUT (4)
SUPPORT INSTALLATION PARTS
LAG SCREw
/ " #7 X 5" (1)
3
8
ONLY.
ADDITIONAL HARDWARE
1" x 8-32 ROUNDED
HEAD SCREw (2)
JOIST
CEILING FAN
APPROVED
wIRING BOX
CROSSBAR
MOUNTING
BRACkET
FLAT
wASHER
APPROVED OUTLET
BOX
HARDwARE
2 " x 8-32 ROUNDED
1
/
4
HEAD SCREw (2)
FLAT wASHER
(2)
LARGE
FLAT wASHER
/ " (1)
3
8
CEILING
wIRING
RIDGE
SIDE
DOwN
GREEN
GROUND
wIRE