Table of Contents
Advertisement
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against
the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
This fan is designed for installation on ceilings with a minimum height of 10 feet from the floor.
The large blades require the use of the 12" extension pole to allow for proper air flow and ventilation.
Allen Set Screw
1/4-20 x 1/4"
(pre-installed)
Prepare for fan installation as follows:
Step 1a. Route the wires from the motor through the
Perma • Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread that is designed
to lock completely when correctly installed.
Step 1b. Using the provided Allen wrench, loosen the set
screw several turns to allow installation of the downrod.
Thread the downrod into the motor coupling until it stops
turning. This will take at least four and a half full turns.
Step 1c. Tighten the set screw securely with the provided
Allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod
before securely tightening the Allen set screw may
cause the fan to separate from the downrod during
normal operation!
Crossbar
Mounting
Bracket
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture outlet
box must be installed and wired.
Warning: To reduce the risk of fire, electrical
shock, or personal injury, mount to outlet box
marked acceptable for ceiling fan support using the
mounting hardware provided with the outlet box.
4
FAN INSTALLATION
IMPORTANT NOTE - CEILING HEIGHT
PERMA*LOCK HARDWARE
3mm
Allen Wrench
FAN PREPARATION
IMPORTANT SAFETY INFORMATION!
Before starting the installation of your ceiling fan, install the threaded
downrod into the motor coupling and lock the assembly
CEILING HARDWARE
Wire Nut (4)
GETTING STARTED
Motor Wires
Tapered
Thread
Allen
Set Screw
ADDITIONAL HARDWARE
1 x 8-32 rounded
head screw (2)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is marked
' A pproved for ceiling fan mounting'. If it is not, a new box must
be installed.
Downrod & Ball
Assembly
Ground Wire
Downrod
& Ball Assembly
Motor
Coupling
2-1/4 x 8-32 Rounded
Head Screw (2)
Flat Washer (2)
Advertisement
Table of Contents
