Table of Contents
Advertisement
Unpacking: Before assembling and installing your ceiling fan,
remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging
material, be certain that all parts have been removed.
ALLEN SET SCREw
⁄
-20 x
⁄
1
1
4
(pre-installeD)
imporTanT safeTy informaTion!
before starting the installation of your ceiling fan, install the
threaDeD DoWnroD into the Motor coupling anD lock the asseMbly
prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma • Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread the
downrod into the motor coupling until it stops turning, this
will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the set screw
may cause the fan to separate from the
downrod during normal operation!
CROSSBAR mOUNT-
INg BRACKET
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.
INSTALLATION INSTRUCTIONS
PERMA • LOCk™ HARDWARE
"
4
allen Wrench
FAN PREPARATION
CEILING HARDWARE
wIRE NUT (4)
GETTING STARTED
V
noTe: Only one set of blade holders is supplied. Depend-
ing on the fan model and series they will be either the
Commodore Style, the Center Style, the Badge Style with
matching badges, or the Standard Style blade holder.
3mm
tapereD
threaD
ALLEN
SET SCREw
addiTional hardware
1" x 8-32 rounD
heaD screWs (2)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked 'Approved for ceiling fan mounting' . If it is
not, a new box must be installed.
®
ictorian
DOwNROD & BALL
ASSEmBLy
mOTOR
wIRES
gROUND
DOwNROD
ASSEmBLy
" x 8-32 rounD heaD
2
1
/
4
SCREwS (2)
flat Washer (2)
wIRE
& BALL
mOTOR
coupling
3
Hide quick links:
Advertisement
Table of Contents
