Installing Instructions; Perma•Lock Hardware; Ceiling Hardware; Important Safety Information - Casablanca Bel Air Instructions Manual

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
iMPortaNt! To avoid possible damage to the Halogen bulb holder the fan must be placed on the styrofoam packaging
from the box. After removing the top cover from the upper half of the styrofoam, take the packaging from the box and
put it on the floor. Place the fan in the recessed circle that the top cover was in.
ALLEN SET SCREW
⁄ -20 x
1
4
(PRE-INSTALLED)

iMPortaNt safety iNforMatioN!

BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN,
INSTALL THE THREADED DOWNROD INTO THE
MOTOR COUPLING AND LOCk THE ASSEMBLy
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma • Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
Step B. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread the
downrod into the motor coupling until it stops turning, this
will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod
before securely tightening the set screw may
cause the fan to separate from the downrod
during normal operation!
CROSSBAR
MOUNTING
BRACKET
Installing a New Ceiling Fixture Outlet box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture outlet
box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked acceptable for
ceiling fan support using the mounting hardware provided
with the outlet box.

INSTALLING INSTRUCTIONS

PERMA•LOCk HARDWARE
⁄ "
1
1/8"
4
ALLEN WRENCH
FAN PREPARATION

CEILING HARDWARE

WIRE NUT (4)
GETTING STARTED
B
el
MOTOR
WIRES
TAPERED
THREAD
ALLEN
SET SCREW
additioNal hardware
1" x 8-32 ROUNDED
HEAD SCREW (2)
Using Existing Ceiling Fixture Outlet box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked 'Approved for ceiling fan mounting'. If it is
not, a new box must be installed.
A
®
ir
DOWNROD & BALL
ASSEMBLY
GROUND
WIRE
DOWNROD
& BALL
ASSEMBLY
MOTOR
COUPLING
2 " x 8-32 ROUNDED
1 /
4
HEAD SCREW (2)
FLAT
WASHER (2)
3