Canon LBP-2000 User Manual page 190

MEM ALLOC ERROR
Cause
Remedy : If AUTOCONT is OFF, you must press [Go] to resume printing. Check the
Reference : "CONFIG MENU" (See p.7-22)
MEMORY OVERFLOW
Cause
Remedy : The printer has received more data than it can hold in the available memory on
MRT COMPRESSION
Cause
Remedy : No action required.
RESTORING DEFAULTS
9
Cause
Remedy : No action required.
TONER CART MISSING
Cause
Remedy : Replace the toner cartridge or, if a toner cartridge is installed, remove it and
9-22 Responding to Error Codes and Messages
: There is not enough memory available to process the data and print the page. If
AUTOCONT is ON (CONFIG MENU), the print job will resume after 10 seconds.
printed page to ensure that it is complete.
: A memory overflow has occurred.
the printer. This can occur if too many soft fonts, macros or complex graphics
are sent to the printer. If AUTOCONT is ON (CONFIG MENU), the print job will
resume after 10 seconds. If AUTOCONT is OFF, you must press Go and the job
will continue printing, although data may be lost. Simplify the print job by
deleting unnecessary fonts or macros from the printer memory.
: The printer is using MRT Compression, which can result in a reduction in print
quality (loss compression).
: This message is displayed when <RESET=MENU> is selected in the RESET
MENU.
: No toner cartridge is installed in the printer, or the toner cartridge is not installed
correctly.
insert it again. Ensure the toner cartridge is positioned correctly.