Table of Contents
Advertisement
To navigate between different control panel views:
1.
Press the menu button (2).
2.
Browse to the target view by turning the control knob (1).
3.
Select the view by pressing the knob (1).
Tip: You can switch between the home view and the previously used view by long pressing the menu button
(2).
3.2.1 Home view
Home view is the control panel work mode after the initial machine and control panel start-up. When in Home view,
the welding current can be adjusted directly by turning the control knob.
Home view in MMA
Depending on your welding settings, the following are shown:
1.
Welding process
2.
Memory channel
3.
Weld Assist symbol
4.
Hot start
5.
Arc force
6.
Recommended welding current range for the selected electrode
7.
Pulse parameters
8.
Wireless remote and its battery status
9.
Remote mode (ON/OFF).
Warning and notification symbols:
a. General notification
•
Yellow: This is a warning that requires attention
•
Red: There is an error that prevents welding
•
Error code is shown below the symbol
b. Operating temperature
•
Red: Welding equipment has overheated
c. VRD (voltage reduction device)
•
VRD symbol on: VRD is on
© Kemppi
23
Master 315
Operating manual - EN
1921530 / 2052
Advertisement
Table of Contents
