3.
Confirm the Weld Assist's recommendation for welding settings by selecting 'Apply'.
Weld Assist automatically sets the following parameters for you:
•
Current: 10 ... 300 A
•
Hot start
•
Arc force
•
Arc break
•
DC+ indicates polarity (in this case the electrode holder is connected to the positive (+) DIX connector).
All these parameters can still be modified as per normal for the actual welding.
Using Weld Assist with TIG welding
1.
Go to the Weld Assist view and select 'Start' with the control knob button (1).
2.
Select:
>> The material you are about to weld: Fe (mild steel) / Ss (stainless steel).
>> The welded material's thickness (0.5 ... 10 mm).
>> The welding joint type: butt joint / corner joint / edge joint / lap joint / fillet joint / tube joint / tube+plate
joint.
>> The welding position: PA / PB / PC / PD / PE / PF / PG.
© Kemppi
26
Master 315
Operating manual - EN
1921530 / 2052