Control panel views:
•
"Home view" below
•
"Weld Assist view" on the next page
•
"Memory channels view" on page 40
•
"Start & stop sequence view" on page 41
•
"Pulse view" on page 44
•
"Current mode view" on page 43
•
"Settings view" on page 46
•
"Info view" on page 49
To navigate between different control panel views:
1.
Press the menu button (2).
2.
Browse to the target view by turning the control knob (1).
3.
Select the view by pressing the knob (1).
Tip: You can switch between the home view and the previously used view by long pressing the menu but-
ton (2).
3.3.1 Home view
Home view is the control panel work mode after the initial machine and control panel start-up. When in Home view,
the welding current can be adjusted directly by turning the control knob.
Depending on your welding settings, the following are shown:
•
Welding current (A)
•
Current mode (AC, DC-, DC+, MIX)
•
Pulse mode: Auto / Selected value Hz (manual)
•
Start & stop diagram
•
Welding mode indicated by the diagram shape: Continuous, Spot or MicroTack
•
Memory channel used
•
Selected trigger logic, ignition mode, remote mode and welding process
•
Warning and notification symbols.
© Kemppi
MasterTig 235ACDC, 325DC, 335ACDC
36/77
Operating manual - EN
1920900 / 1939