General Setting - Delta DPS Series User Manual

7.6.7

General Setting

Path: → General Setting
Item Sub Item
Date Format
DATE/
Date
TIME
Time
Screen Brightness
SCREEN
Screen Sleep
(after)
Language
On/ Off Button
Access
Admin Password
MODBUS ID
USER
Baud Rate
MODBUS Mapping
Table
Dust Filter
Installation
Dust Filter
Installation Date
DUST
FILTER
Dust Filter
Replacement Date
Ultron DPS Series
Select the date format.
Set up the date.
Set up the time.
Adjust the LCD display brightness (default: 80).
Set up the LCD backlight sleep time (default: 1
minute).
Set up the display language (default: English).
Set up the access for the ON/ OFF Button (
'Any User' or 'Administrator Only'.
Set up the administrator password (4 digits).
Set up the MODBUS ID for the MODBUS port located
at the rear of the touch panel.
Set up the baud rate for the MODBUS port located at
the rear of the touch panel.
Set up the MODBUS mapping table (default: Table
B).
Table A: Compatible with Delta MODBUS card.
Table B: Applicable to DPS Gen2 MODBUS.
If you have installed any dust filter, please select
'Enable'; if not, please select 'Disable'.
Set up the dust filter installation date.
NOTE:
Only when you select 'Enable' for 'Dust
Filter Installation' can you set up the item.
Set up the dust filter replacement date.
When the date is due, the red warning icon (
automatically appear in the upper right corner of the
LCD, and the alarm message 'Replace Dust Filter'
will be displayed.
118
Description
) as
) will