Manager; Setting Up Fax Options In The Desktop Manager - Canon MultiPASS L6000 Software Manual

Setting Up Fax Options in the Desktop

Manager

The Desktop Manager contains setup options that define the operation of
faxing with your MultiPASS printer. Although you can set MultiPASS fax
options directly in the device itself, you can also set the options in the
Desktop Manager. You can set options that affect general operation
preferences, sending a PC fax, receiving a fax, and using the speed dial.
When you first install the Desktop Manager, setup options are set to
appropriate default settings. The default settings enable you to begin
using your MultiPASS printer with the Desktop Manager immediately.
However, you can change option settings as needed.
Since you can make changes to most option settings either on the
MultiPASS printer or in the Desktop Manager, be aware of the following:
Any option setting you make on the MultiPASS printer does not
appear in the Desktop Manager Setup Options dialog box.
Any change you make to an option in the Desktop Manager
overrides the corresponding setting you may have made on the
MultiPASS printer device itself.
Therefore, before you make changes to these option settings, decide
where you prefer to make your changes — on the MultiPASS printer or in
the Desktop Manager. Establishing a preference for changes will help you
avoid inadvertently overriding your previous settings.
n
When the MultiPASS printer is connected to your PC, we recommend
that you use the setups dialog boxes in the Desktop Manager. Do not
make your changes using the operation panel of the MultiPASS printer.
The following instructions summarize the overall procedures for
changing MultiPASS printer setup options in the Desktop Manager. For
additional detailed information, refer to later sections in this chapter.
8-2 MultiPASS Printer Setup and Other Utilities in the Desktop Manager Chapter 8