Overwriting The Multipass Printer Options - Canon MultiPASS L6000 Software Manual

For information about allowing the Desktop Manager software to
overwrite the MultiPASS printer setup options, refer to the "Overwriting
the MultiPASS Printer Options" section.

Overwriting the MultiPASS Printer Options

If you set options on the operator panel of your MultiPASS printer (such
as a phone line type), they are overwritten by the Desktop Manager
software under the following conditions:
When the installation of the Desktop Manager software is completed
and you select to launch the MultiPASS Status Monitor
After installation, when you open the MultiPASS Status Monitor
(which occurs automatically when you start Windows NT)
After installation, when you save a change to the setup options in the
Desktop Manager (as described in Chapter 8, "MultiPASS Printer
Setup and Other Utilities in the Desktop Manager").
When setting options, a message appears to remind you that the
MultiPASS printer options set on the operator panel will be
overwritten if set in the Desktop Manager.
You can choose to proceed with the update, overwriting the settings
in the MultiPASS printer, or you can cancel the action. When
canceling, you can first record your settings on the MultiPASS
printer. This enables you to reenter them in the Desktop Manager
when you resume operations.
2-6 Installing the Desktop Manager Software
Be sure to wait for Windows NT to complete each setup step. If
you hear the computer working, wait until it is done.
Chapter 2