Preparing To Share Your Printer Cross-Platform - Canon MultiPASS C80 Software User's Manual

Sharing Your Printer Cross-Platform in
If you are using Windows NT and expect Windows 95/98 client systems
to use your shared MultiPASS printer, you need to set up an alternate
driver for Windows 95/98.
To set up an alternate driver, it is recommended that you have the
following:
Service Pack 4 or later installed on your Windows NT system
Windows NT, Windows 95/98, and MultiPASS Suite installation
disks available for use during the setup.
The following procedures are based in part on information from the
Microsoft Knowledge Base (Articles Q154291 and Q174333), located on
the Microsoft web site (www.microsoft.com).
Preparing to Share Your Printer Cross-
Platform
Before you begin the actual setup, you need to prepare certain files for
sharing your printer cross-platform. In the case of a Windows 95 driver,
you need to extract the Windows 95 cabinet files into a location accessible
your Windows NT system, such as a CD-ROM or a user-defined folder
on your system. You need to extract the following cabinet files:
Precopy2.cab, Win95_09.cab, and Win95_10.cab.
Appendix B Sharing Your Printer Cross-Platform in Windows NT B-1
Appendix B
Windows NT