Setting Up Fax Options In The Desktop Manager - Canon MultiPASS C80 Software User's Manual

Setting Up Fax Options in the Desktop
Manager
The Desktop Manager contains setup options that define the operation of
faxing with your MultiPASS printer. Although you can set MultiPASS fax
options directly in the device itself, you can also set the options in the
Desktop Manager. You can set options that affect general operation
preferences, sending a PC fax, receiving a fax, and using the speed dial.
When you first install the Desktop Manager, setup options are set to
appropriate default settings. The default settings enable you to begin using
your MultiPASS printer with the Desktop Manager immediately. However,
you can change option settings as needed.
Since you can make changes to most option settings either on the
MultiPASS printer or in the Desktop Manager, be aware of the following:
Any option setting you make on the MultiPASS printer does not
appear in the Desktop Manager Setup Options dialog box.
Any change you make to an option in the Desktop Manager overrides
the corresponding setting you may have made on the MultiPASS
printer device itself.
Therefore, before you make changes to these option settings, decide where
you prefer to make your changes — on the MultiPASS printer or in the
Desktop Manager. Establishing a preference for changes will help you
avoid inadvertently overriding your previous settings.
n
When the MultiPASS printer is connected to your PC, we recommend that
you use the setups dialog boxes in the Desktop Manager. Do not make your
changes using the operation panel of the MultiPASS printer.
The following instructions summarise the overall procedures for changing
MultiPASS printer setup options in the Desktop Manager. For additional
detailed information, refer to later sections in this chapter.
8-2 MultiPASS Printer Setup and Other Utilities in the Desktop Manager Chapter 8