Victoria Arduino Adonis+ 2 Gr Technical Manual page 77

Use the keys to vary the starting up time.
Press ENTER to confirm and to go on to the pro-
grammed switching off time (the message OFF
23.30 will start to flash on and off).
Use the keys to vary the switching off time.
Confirm by pressing ENTER.
To de-activate the on/off function on weekly day-off,
press RESET.
The display will read:
DAY OFF
(to reinstate, press RESET)
After the word SUNDAY, by pressing
beep will signal that you have come to the following
page.
ENERGY SAVING (stand-by)
The display will read:
ENERGY SAVING
This function allows the machine to enter an active
STANDBY status, where it is possible to choose whether
to switch off the machine completely or to keep it at a set
pressure (lower than working pressure).
Press ENTER and the display will read:
ENERGY SAVING
XXX
Here it is possible to select the XXX mode using the
keys.
The 4 operating modes are:
OFF: during STANDBY the machine is switched off
again, a and the display reads "OFF";
STANDBY 0.10 bar: during STANDBY, the machine
maintains a pressure of 0.10 bar and the display (set
to minimum brightness) reads "LOW POWER USE";
STANDBY 0.50 bar: during STANDBY, the machine
maintains a pressure of 0.50 bar and the display (set
to minimum brightness) reads "LOW POWER USE";
STANDBY 0.80 bar: during STANDBY, the machine
maintains a pressure of 0.80 bar and the display (set
to minimum brightness) reads "LOW POWER USE".
This type of operation is possible when switching the
machine on/off manually using the RESET key and
when switching the machine on/off automatically using
the ON/OFF programming function.
If the RES key is pressed while the machine is in one
of the standby conditions (0.10 bar, 0.50 bar, 0.80 bar),
the machine switches to OFF. If the key is pressed
again, the machine enters the ON mode.
Press the ENTER key to confirm the mode selected
from the display and go back.
Press the RESET key to go back without confirming.
SETPOINT TEMPERATURE
(AND OFFSET) (Version T3 only)
It is possible to access this function by pressing the
ENTER key .
The key serves to adjust the temperatures
of the boilers and units; the ENTER key is used to
confirm and pass to the next value. When the last
75