Victoria Arduino Adonis+ 2 Gr Technical Manual page 76

To access the automatic cleaning counter press
ENTER.
The long coffee keys
begin to flash; when the group key is pressed, the
display will show the number of wash cycles carried
out. Hold down the RESET key for 3 seconds to
reset.
ACTIVE UNITS (T3 version only)
It is possible to set both the units actually present
and those to be enabled when the control unit is
switched on. To set the number of active units when
the machine is switched on and to change the ac-
tive units, proceed as follows:
Switch on the function by pressing the ENTER key.
It is possible to activate/deactivate individual units
by pressing the
firm and to pass on to the next unit. When the last
unit is confirmed, the function returns to the main
menu.
Pressing the RESET key returns to the main menu
and any changes made will not be saved.
74
NOTE: To make a change effective, it is necessary to
, on the machine will
NOTE: From the machine ready state, it is possible to
NOTE: If the electronic control unit is replaced, when
keys. Press ENTER to con-
switch the machine off and then on again, using
the main switch located in the bottom right.
activate/deactivate the deactivated/activated
units by pressing the key and the button for
the unit in question. This temporary change is
active until the machine is switched off and then
on again from the main switch.
the "ACTIVE UNITS" are shown on the display,
it is necessary to press the long coffee key
for the first and second group to make sure that
in the "ACTIVE GROUPS X" on the display, X
actually corresponds to the number of units in-
stalled on the machine.
It is possible to change the value with the
keys.
For machines with 2 units, the value should be
X=2, for machines with 3 units, the value
should be X=3, for machines with 4 units, the
value should be X=4.
PROGRAM. ON/OFF
The display will read:
ON-OFF PROGRAM
By pressing the ENTER, the display will read:
MONDAY
ON 07:30 OFF 23.30
where the ON and OFF values indicate when the
machine will turn on and off.
Press to change the day forward and back-
ward.
Press ENTER to vary the programmed starting up
time (the message ON 07:30 will start to flash on
and off).