Victoria Arduino Adonis+ 2 Gr Technical Manual page 72

Press ENTER and the display will read:
AUTO.CLEAN.CYCLE
SELECT
The central key in each unit
on and off. Insert the blind filter (Fig. 2 A06) into
the filter-holder, add half a dose of PULICAFF
and attach the filter-holder into the unit where you
intend to carry out the automatic cleaning cycle.
It is possible to wash more than one group at the
same time.
Press the key to start the unit automatic
cleaning cycle. The display will read:
AUTO.CLEAN.CYCLE
¡ L
where 1L indicates that the cleaning cycle has
70
been activated within the 1st unit. Once the
cycle of 15 deliveries of 5 seconds each, with a
10-second pause between each delivery, has been
completed the selected unit
flash on and off again and the display will read.
will begin to flash
Eliminate any residues of PULICAFF from the blind
filter and press
key of the unit or units where the cleaning cycle
has been effected. The letter R will remain on the
display like the key
the selected unit or units has been completed, the
display will read.
If ACTIVE has been selected in the function "DELIVER
key will begin to
RINSE
the rinsing cycle starting up
. Once the rinsing cycle of
MACHINE READY
WHILE WASHING" (see function), after the groups to
be cleaned have been selected, pressing the ENTER
key will quite the washing mode to use the other, non-
selected units to deliver coffee.
When the washing mode is closed to make the units
not being washed available to deliver coffee, the wash-
ing cycle will be shown in the top or bottom line of the
screen, according to the choice made in the "DELIV-
ERING TIME" menu. If the delivering times are deac-
tivated, the washing process will be displayed on the
bottom line.
It is not possible to open the setting menu and to switch
off the machine, either manually or automatically, during
an automatic washing cycle not in the menu (therefore,
with delivering enabled).
PROGRAMMING DOSES
The display will read:
PROGRAM. DOSES