Testing - GRASS VALLEY NV9000 User Manual

3 The panel now allows you to enter the panel ID using the panel's standard numeric
keypad (the same as the fixed category buttons when the panel is operating under the
NV9000 system). The ID you enter is displayed on the first button:
–––– 6061
––––
After you enter the panel ID using the keypad, press 'Save' . You can press 'Cancel' if you
make a mistake.
The panel returns to the menu, at which point you should click 'Exit' .
4 The second LCD button should display 'Acquire IP Address' once again as in step 1.
5 When you finish, reconnect the Ethernet cable. The system controller will detect your
panel in a few seconds. (All panel IDs must be unique.)
You can now prepare an NV9616 or NV9608 configuration in NV9000-SE Utilities and
upload the configuration to the NV9616 or NV9608. You need the panel ID to create a panel
configuration. When you upload the configuration, the panel ID you entered in NV9000-SE
Utilities designates the actual panel to which the upload will occur. If no actual panel has
that ID, the upload cannot occur.

Testing

A panel test function is available when the NV9616 or NV9608 is disconnected from the
system controller. Run the test to determine the health of your panel. See
page 54
These are points to consider after you install your control panel(s):
1 Do the buttons illuminate? When an NV9616 or NV9608 powers up, one or more of its
buttons are supposed to turn green or amber. Does it pass the panel test mentioned
above?
2 When the NV9616 or NV9608 powers up and it is connected to the system controller, it
should initialize completely. (That takes a few seconds.) The NV9000 system should
load whatever configuration exists for that panel and the buttons appropriate for its
configuration should light.
If you continue to see "No Server, " "Acquire IP Address, " or "Locating Network, " you have
a problem. Reboot everything and try again.

PANEL PANEL
ID ID
6061
for detail. You can also view the software version numbers under setup mode.
The panel, by default, acquires its IP address through DHCP on the system
controller's panel/router network. You can use the Panel IP Configuration Utility to
force the panel to have a static IP address.
The numbers of the
keypad are shown here
NV9608 and NV9616
User's Guide
CANCEL CANCEL SAVE SAVE
1 2 3
4 5 6
7 8 9
0
Setup Mode on
11