GRASS VALLEY NV9000 User Manual page 27

XY Data Automatic
Routing Mode
Semi-automatic
(recommended)
Manual
MD Data Automatic
Routing Mode
Manual
Default Name System Name
Set
Multidest 16 (or 8)
Device Limit
a. See Defaults on page 81.
If a machine control (data) level is involved in the route,
make the route on the control level even if the control port
is in use on the source or destination device.
If the machine control port is in use on the source or
destination device, take all levels except control and allow
the user to perform the control level route by pressing 'Take'
a second time. If 'Take' is not pressed again, the route is
cancelled.
If the control port is not in use, the control level take occurs
automatically.
A take on the data level must be performed manually as a
breakaway on the control level. The control level will never
switch as part of a multi-level take.
If a data level is involved in the multi-destination route,
connect the source to the destinations, regardless of who is
currently using the devices. (Recommended.)
All multi-destination takes on the data level must be
performed manually as breakaways. The data level will
never switch as part of a multi-level take.
A list of "name sets" appears in the drop-down menu. The
name sets can be defined under the System Management
pane of NV9000-SE Utilities. Choose 'System Name' in this
list if you do not want, or do not care about, device name
aliases. Do not choose 'System Name' if you are configuring
any 'Name Set Toggle' buttons.
This scroll box allows you to specify the maximum number
of MD devices, up to 512. The values increment or
decrement by 16 for the NV9616 and by 8 for the NV9608.
The default value is the minimum value which is 16 for the
NV9616 and 8 for the NV9608.
NV9608 and NV9616
User's Guide
19