GRASS VALLEY NV9000 User Manual page 29

• Deselect all destinations and turn off hold after take.
After selecting many MD destinations (with 'Hold' mode on), it can be time-consuming
to find them all (and no others) to deselect them after a take. When you enable this
option, the NV9616 does exactly that (and turns off hold mode).
You should not check this option unless you configure the panel with a 'Hold' button so
the operator can turn hold mode back on.
• Jump to multi-dest selection when switching to XY.
Makes the currently selected multi-destination device the preset destination when you
switch from MD mode to X-Y mode.

The X-Y destination chosen is unpredictable when the panel is in MD "hold" mode
and multiple destinations are selected.
• Flip-flop source to preset after take.
Swaps the preset source and the currently routed source for this destination.
• Lock page after timeout.
If you check this box, the panel will lock the current MD destination page after the
panel is idle for the timeout period.
To clear the lock, operators can press any enabled function button.
See Setting the Timeout Value
• Clear preset when going from low tally to high tally.
If you check this box, the panel lets the operator clear a preset (in MD mode only) by
deselecting and reselecting a destination. When you deselect the destination, it goes
low-tally, and when you reselect it, it goes high-tally.
This method does the same thing a 'Clear' button does, but it does not require a 'Clear'
button. This might be advantageous if you want some other button in place of a 'Clear'
button.
• Use continuous scrolling.
If you check this box, the panel scrolls MD destinations continuously. That is, the MD
destination pages wrap around at the beginning and at the end of the page list.
The LCD buttons will show the first page in the list following the last when you are
scrolling down, and will show the last page following the first if you are scrolling up.
If you uncheck this box, the panel will stop scrolling when it reaches either the
beginning or end of the page list.
This option does not affect scrolling of salvos when the panel is in salvo mode or levels
when the panel is in X-Y mode.
• Clear Preset Mapping.
If you check this box, all preset mappings (channels, or levels, mapped and tieline
presets) clear at the beginning of each suffix button press.
If you clear this check box, all preset mappings are retained. Note that the most recently
made tieline preset (if one was made) is retained even if the ultimately taken source
does not require a tieline. The tieline is wasted.
on page 63.
NV9608 and NV9616
User's Guide
21