Setup Mode; Setting The Panel Id - GRASS VALLEY NV9000 User Manual

Operation

Setup Mode

Setup Mode
Setup mode occurs when the NV9616 is disconnected from its network and is freshly
powered up. In setup mode, you can set or change the panel ID, identify the software
version, and perform a test of the panel's buttons. It is in setup mode that you must initially
set the panel ID.
After a few seconds, the LCD buttons will show 'Acquire IP Address' on the second button
and the panel's current panel ID on the first button. The right-hand button is designated
the menu button:
NV9616 NV9616
PANEL ID PANEL ID
0 0
Press the menu button to proceed to the setup menu:
PANEL PANEL
ID ENTRY ID ENTRY
There are 3 submenus: panel ID entry, software versions, and panel test mode.
Press the menu button to proceed to the first part of setup which is to set the panel ID:
PANEL PANEL
ID ENTRY ID ENTRY

Setting the Panel ID

The keypad buttons on the right become enabled. Enter a panel ID (up to 8 digits):
PANEL PANEL
ID ID
–––– 6061 6061
––––
Press 'Cancel' to cancel the entry or press 'Save' to save the new panel ID. In either case, the
panel returns to the setup menu.
54
ACQUIRE ACQUIRE
IP IP
ADDRESS ADDRESS
SOFTWARE SOFTWARE PANEL PANEL
VERSIONS VERSIONS TEST TEST
MODE MODE
SOFTWARE SOFTWARE PANEL PANEL
VERSIONS VERSIONS TEST TEST
MODE MODE
MENU MENU
EXIT EXIT
EXIT EXIT
CANCEL CANCEL SAVE SAVE
1 2 3
4 5 6
7 8 9
0