GRASS VALLEY NV9000 User Manual page 33

Type Description
Hold In multi-destination mode, Hold retains destination selections after a take. In
X-Y mode, Hold retains breakaway levels after a take.
The button definition has no fields to configure.
Information Although an information button is present in the drop-down menu for
button types, you should not configure an information button on the panel,
because an information button does nothing.
Level Map Cross-connects levels (in the same physical router). The function is typically
used to shuffle audio channels, for example, to connect AES1/2 to AES3/4.
The level map mode is cancelled when the next normal take is performed
involving the selected destinations.
The button definition has no fields to configure.
Load Preset The 'Load Preset' button creates a preset for MD destinations using one of
the presets the operator saved with a 'Save Preset' operation. See
Loading Presets
The button does not operate in X-Y mode.
The button definition has no fields to configure.
 The 'Load Preset' button and 'Save Preset' button are not supported in
an NV915. They are fully functional in an NV920 or NV960.
Menu This button puts the NV9616 panel in menu mode and displays a menu on
the LCD buttons that provides access to a variety of panel functions. Without
the button, the operator has no access to the menu functions.
Using the menu, the operator can change the panel ID (if the configuration
permits it) or change button brightness values. Administrators could use the
menu to determine the panel's software revision, IP address, user ID, or
configuration name. See
The button definition has no fields to configure.
Name Set The button toggles the panel between its default name set and the "system
Toggle name" set. One or the other becomes the active name set.
The button definition has no fields to configure.
If the default name set is the system name set, the button would be a no-op.
Therefore configurers should not create a 'Name Set Toggle' button if the
default name set is 'System Names' .
The status, preset, or destination displays use the active name set — either
the default name set (aliases) or the system name set. However, that when
the panel is displaying aliases, and a device does not have an alias, the panel
displays the system name.
Panel Lock The button prevents accidental changes to the panel settings, especially
router crosspoints. When the panel is locked, the button array becomes
blank except for the Panel Lock button which becomes high tally amber.
Pressing the panel lock button again reverts the panel to its previous state.
The button definition has no fields to configure.
on page 45.
Menu Mode on
NV9608 and NV9616
page 48.
User's Guide
Saving and
25