Table of Contents
Advertisement
digits you enter appear on the button next to the 'Clear' button at the right. If you make
an error, press the 'Clear' button to start over.
0 0
5 Then press the 'Save' button (on the right) to save the ID, or press the 'Clear' button to
discard the ID.
The new panel ID does not appear until you exit the menu after saving.
6 You may use any other menu function at this time. When you are finished, press the
'Exit' button (which reappears) to leave the menu.
7 After you designate the panel ID, reconnect the Ethernet cable. The system controller
will detect your panel in a few seconds. (All panel IDs must be unique.)
You can now prepare an NV9680 configuration with GV-Orbit and upload the configuration
to the NV9680. You need the panel ID to create a NV9680 configuration in GV-Orbit. When
you upload the configuration, the panel ID you entered in GV-Orbit designates the actual
panel to which the upload will occur. The panel might be a physical panel or a virtual panel.
If no actual panel has that ID, the upload cannot occur.
Testing
As shown above in step 3 above, a panel test function is available when the NV9680 is
disconnected from the system controller. The test determine the "health" of the buttons of
your NV9680. See
review the versions of installed software and firmware.
These are points to consider after you install your NV9680 control panel(s):
1 Do the buttons illuminate? When an NV9680 powers up, its two leftmost LCD buttons
are supposed to turn green. Does it pass the panel test mentioned above?
2 When the NV9680 powers up and it is connected to the GV-Orbit Server, it should
initialize completely. This takes a few seconds. GV-Orbit should load whatever
configuration exists for that panel and the buttons appropriate for that configuration
should light in the colors appropriate for the top-level button page of that
configuration.
If you continue to see "No Server," "Acquiring IP Address," or "Locating Network" on
button 2, you have a problem. Reboot everything and try again.
3 Is the GV-Orbit Server actually running? Open GV Orbit Control. You can view the
health of the panel in the System Status task. Refer to System Status Task in the GV Orbit
Control User Guide
4 Does the configuration actually work? Is it useful? Can the operator perform takes and
perform other operations?
1 1
2 2
3 3
4 4
5 5
Setup Mode
on page 14 for detail. Press the 'Software Versions' button to
The NV9680, by default, acquires its IP address through DHCP on the NV9680's IP
network. You can use the Panel IP Configuration Utility to force the panel to have a
static IP address.
or GV Convergent User's Manual. See
6 6
7 7
8 8
9 9
Related Documentation
NV9680
User's Guide
PANEL ID
PANEL ID
PANEL ID
PANEL ID
CLEAR
CLEAR
SAVE
SAVE
65410
65410
1234
1234
, on page 2 .
EXIT
EXIT
11
Advertisement
Table of Contents
