Table of Contents
Advertisement
Remote Menu Access
This displays TELNET menus for a remote device (may be
another TSU/TDU or any other ADTRAN product that sup-
ports TELNET via its EIA-232 chain port). After selecting this
option, the user may:
1.
2.
Management Configuration
This menu sets management information, such as SNMP com-
munity names and trap destination addresses.
Unit Access Table
This menu creates and edits the Unit Access Table. This table
stores the Unit ID, Passcode, and Unit Type for units connected
via chain ports or connected remotely to the TSU/TDU (see
Unit Access Table on page 8-6). An entry in the table is required
only to support proxy SNMP MIB access or polling. For MIB
access, an entry is required only if the unit's passcode is not the
same as the Default Unit Passcode, or the unit is a single port
TSU standalone.
Units accessed via T-WATCH Pro over TCP/IP use the Unit ID
and passcode set by T-WATCH Pro running on the PC.
61202129L1-1
Choose to connect to a device entered in the Unit Access
Table or
Enter a Unit ID for a unit not listed in the Unit Access
Table.
terminates the session and returns to the
CTRL + X
TSU 120 Main menu.
It is not necessary to have an entry in this table for a remote unit
in order to TELNET to it or forward SNMP traps from it. In the
TELNET case, the Remote Menu Access menu is selected from the
Main Menu and a Unit ID is entered which may or may not be in
the Unit Access Table.
TSU 120 User Manual
Chapter 8. Telnet/Terminal Menus
8-5
Advertisement
Table of Contents
