Table of Contents
Advertisement
Chapter 7. Test Menu
The self-test consists of the following tests:
A test pattern is sent from the controller through a loopback on
all other boards and is checked on the controller. This verifies
the data path, clocks, and control signals.
If a failure is detected, note the failure number and contact
ADTRAN Technical Support.
Port Tests
The Port Tests menu is used to activate testing of specific data
ports. It controls the activation of loopbacks and the initiation
of data test patterns. Test results are displayed in the LCD win-
dow.
7-8
B
L
T
OARD
EVEL
ESTS
U
L
T
NIT
EVEL
ESTS
Executing the self-test will disrupt normal data flow and prevent
remote communication until it is complete.
Port tests execution will disrupt normal data flow in the port be-
ing tested.
TSU 120 User Manual
Each of the TSU 120 boards contain an
on-board processor which executes a
series of tests checking the circuitry
on the board.
•
RAM tests; EPROM checksum
•
DS0 map tests
•
On-board data path; sending a
known test pattern through an on-
board loop
•
Front panel LED verification
•
Phase Lock Loop verify
•
Board-to-board interface test
61202129L1-1
Advertisement
Table of Contents
