Table of Contents
Advertisement
Power Up Testing
When shipped from the factory, the TSU 120 is set to factory
default conditions. At the first application of power, the unit
automatically executes a memory self-test. A full self-test can
be run from the front panel. A passcode and Unit ID may be
set using the UTIL M
Self-Test
Upon a power-up, the LCD displays
and the Test LEDs are illuminated. When the self-test is com-
pleted with no failures detected, the OK LED lights up and the
LCD momentarily displays M
ure is detected, a list of failures is displayed in the LCD win-
dow.
Initialization
Set User Passcode
The TSU 120 is designed to operate with or without the use of a
passcode. The default condition is without a passcode.
The passcode should be a number easily remembered. Once
entered, the passcode is required to access any operation other
than viewing. See Change/Set a Passcode on page 6-4 for details.
Set Unit Identification
The Unit ID sets the unit to respond to remote control (con-
trolled by a device other than the front panel or terminal). If no
Unit ID is recorded it is not possible to operate from any remote
control device, including the local PC for T-WATCH Pro or
SNMP. See Unit ID on page 6-4 for details.
61202129L1-1
ENU
If the unit is to be remotely accessed using T-WATCH Pro, you
must enter a passcode. When managing a number of units, the
passcode can be the same for all the units.
TSU 120 User Manual
.
M
EMORY
T
(
EMORY
EST
Chapter 2. Installation
T
N
T
EST
OW
ESTING
. If a fail-
) P
S
ASSED
2-7
Advertisement
Table of Contents
