7
Startup
7.1
General startup instructions
INFORMATION
•
•
•
•
•
7.2
Startup options
No drive safety function is approved in the delivery state of the basic device with
MOVISAFE
system error, the safety option is fully functional. The safety option permanently activ-
ates the STO function.
7.2.1
Variant 1: Startup with default parameterization
After the PROFIsafe protocol has been activated, the MOVISAFE
tion can be taken into operation with the default parameterization of the drive safety
functions.
Take into account the following constraints for this operating mode:
•
For startup, perform the following steps:
1. The PROFIsafe protocol of the MOVISAFE
2. Startup of the safe fieldbus and the higher-level F-PLC.
The startup procedure of the standard functions of the basic device is described in
the respective operating instructions.
Observe the information in chapter "Compatibility".
The following chapters describe the additional startup procedure for the
®
MOVISAFE
CSB51A safety option and the drive safety functions.
Note the prerequisites for installation and operation of MOVISUITE
When starting up several similar devices with identical parameterization, the
devices can be parameterized via the "Import/Export" function. Note that you must
accept every single device to accomplish this.
®
CSB51A safety option. A system error is issued. After acknowledging the
The PROFIsafe protocol of the MOVISAFE
ing the "Assist CS.." parameterization tool.
ing the "Assist CS.." parameterization tool.
Ensure that the default parameterization of the MOVISAFE
is active. To do so, check the following parameters (see following figure).
•
The status of the parameterization of the safety option is "Accepted".
General startup instructions
®
CSB51A safety op-
®
CSB51A safety option is activated us-
®
CSB51A safety option is activated us-
®
CSB51A safety option
®
Manual – MOVISAFE
CSB51A Safety Option
Startup
7
®
.
21
Need help?
Do you have a question about the MOVISAFE CSB51A and is the answer not in the manual?