SEW-Eurodrive MOVISAFE CSB51A Manual page 24

Startup
7
Parameterization of the drive safety functions
24
Manual – MOVISAFE
6. Parameterization
Set the parameterization according to your safety-related requirements of your ap-
plication.
For parameterization of the MOVISAFE
sections in the parameter tree and enter the required values. The higher-level pa-
rameters such as start inhibit after power on, muting, maximum muting time and
enable emergency mode can be set in the "Basic settings" area. The correspond-
ing F-protocol is set in the section "Communication". After this, the parameters of
the drive safety functions STO and SS1(c) are set.
The "Assist CS.." parameterization tool creates a new parameter set from all of the
parameters.
7. Transferring the parameter set to the device
Click the [Download]
®
MOVISAFE CSB51A safety option.
After the download, the transferred parameter set is checked for consistency and
plausibility. Possibly existing inconsistencies or plausibility errors are displayed
and can then be corrected.
For a detailed description of steps 4 – 7, refer to chapter "Assist CS..".
Once the parameter set has been transferred to the MOVISAFE
tion without any errors, you can start up the standard functions and make the connec-
tion to the higher-level safety controller (F-PLC).
®
CSB51A Safety Option
®
CSB51A safety option, call the individual
button to transfer the parameter set to the
®
CSB51A safety op-