Checking And Replacing The X2 Head - medemagroup Mini Crosser X2 4W Service Manual

Medema A/S
Service manual 1533-2002-S

Checking and replacing the X2 head

If you want to check if the Mini Crosser communicates with
the head, you must go for a drive and check that it runs at full
speed with the settings it has now.
Then "Max fwd speed fast" in the service menu changes, from
"100%" to "50%" and you go for a drive again, and find out if it
now runs at half speed compared to before. If it run as fast as
before, there is no communication between the head and the
scooter and the head needs to be replaced. Follow the proce-
dure below.
Press the "Menu button" and "+" button at
the same time.
Scrol down in the service menu untill you
find P&G menus. Find the menu "Max
fwd speed fast".
Use the "+" button and "Next" button to
enter the code 1111. Finish with "Enter".
If there is no communication, a lot of
these values will be "1". If that is the
case - go directly to page page 78
Replacing the X2 head.
Or:
Press "Enter" to change the value. Use
the "-" (minus) button untill the value is
"50%". Press "Enter" again to accept the
new value.
77 of 122 Version 1.0.5 - 2021