Table of Contents
Advertisement
Medema A/S
Service manual 1533-2002-S
Troubleshooting
The following is a list of various problems that, in our experi-
ence, may occur. The list gives possible causes and remedies.
Problem
The user panel is com-
pletely black, even though
there is voltage on the
batteries and the key is
turned to I (on).
The battery indicator
shows 1 bar and the bat-
tery voltage in the menu
shows 20.1 V
The battery indicator
shows that a charger is
connected, but it is not
true.
Diode in the lower left
corner is constantly lit.
Tilt does not work in X
and Y. Shows very large
numbers or jumps up and
down in values.
The Low Thermal Switch
symbol appears without
the engine overheating.
The Mini Crosser will not
go.
The battery indicator is
not lit.
The Mini Crosser will not
go.
The battery indicator is lit.
The Mini Crosser goes
uneven, choppy while
driving.
Possible causes
Printed circuit boards in
the user panel is dama-
ged.
Printed circuit boards in
the user panel is dama-
ged.
Printed circuit boards in
the user panel is dama-
ged.
Printed circuit boards in
the user panel is dama-
ged.
Printed circuit boards in
the user panel is dama-
ged.
Printed circuit boards in
the user panel is dama-
ged.
The key has not been
turned to start.
The batteries are com-
pletely flat.
The control fuse has
blown.
The main fuses have
blown.
The Mini Crosser has
been overloaded.
The hand brake is on.
There is a fault in the
electronics.
The batteries are flat.
The charging plug has not
been removed.
May be due to poor con-
nection in the electricity.
67 of 122
Remedy
The X2 head needs to be
replaced
Contact your supplier.
The X2 head needs to be
replaced
Contact your supplier.
The X2 head needs to be
replaced
Contact your supplier.
The X2 head needs to be
replaced
Contact your supplier.
The X2 head needs to be
replaced
Contact your supplier.
The X2 head needs to be
replaced
Contact your supplier.
Turn the key and wait 5
sec. before activating the
accelerator.
Charge the batteries.
Change the fuse.
Contact supplier.
Wait approx. 1 min. before
trying again. The vehicle
must be turned off.
Release the hand brake.
Contact supplier.
Contact supplier.
Remove the charging
plug.
Turn off the Mini Crosser
immediately and search
for authorized workshops.
If you continue to drive,
heat development may
occur in the poor connec-
tion, with a risk of fire.
Version 1.0.5 - 2021
Advertisement
Table of Contents
