Appendix A - Electric Faults - medemagroup Mini Crosser X2 4W Service Manual

Medema A/S

Appendix A - Electric faults

Code Description
0003 EEProm cache checksum
0100 ROM checksum trip
0200 EEProm cache checksum
0300 Parallel speed pot wiper open-
circuit
0704 Internal 12v supply Fault
0815 Throttle reference fault
0816 Throttle reference fault
0A00 Sleep timer
0A01 Keyswitch has been turned off
0E07 Throttle ISO Test Fault
Throttle ISO Test Fault
0E08 Throttle wiper fault
Throttle wiper fault
1310 Overcurrent fault
1500 Solenoid Brake Fault
1502 Solenoid Brake Fault
Solenoid Brake Fault
1504 Solenoid Brake Fault
1600 Battery voltage too high
Battery voltage too high
1601 Battery overvoltage Trip
1703 Relay interlock fault
1705 Possible Relay Fault
Possible Relay Fault
Service manual 1533-2002-S
Action Mode Bars Comments
Trip All modes 8
Trip All modes 8
Trip Startup 8
Limp All modes 7
Trip All modes 8
Trip All modes 7
Trip Startup 7
Trip Standby 6
Trip All modes 6
Trip Startup 7
Trip All modes 7
Trip Startup 7
Trip All modes 7
Trip Drive 8
Trip Drive 9
Trip Startup 9
Trip Standby 9
Trip Startup 8
Trip Startup 10
Trip All modes 10
Trip All mo- 10
dels
Trip Startup 8
Trip Startup 8
Trip Standby
118 of 122
Internal Fault. Return to PGDT if
happening all the time.
Internal Fault. Return to PGDT if
happening all the time.
Internal Fault. Return to PGDT if
happening all the time.
Only tested if speed pot enabled.
Internal Fault. Return to PGDT if
happening all the time.
Value checked for valid range. Tests
only if "reference tests" enabled
Startup
If active (greater than 0) then it will
pulse trucharge gauge, recycle
keyswitch to reset.
Informs of rapid power cycle on key-
switch input, controller may not reset
correctly
Test only if ISO tests enabled, 10K
resistor, in series with wiper
Test only if ISO tests enabled, 10K
resistor, in series with wiper
Trips if throttle wiper exceeds limits
Trips if throttle wiper exceeds limits
Internal Fault. Return to PGDT if
happening all the time.
Trips if solenoid brake is short-circui-
ted, if test is enabled.
Trips if solenoid brake is short-circui-
ted, if test is enabled
Trips if solenoid brake is short-circui-
ted, if test is enabled
Internal Fault. Return to PGDT if
happening all the time.
Battery voltage is greater than 35.0V
Battery voltage has risen above
35.0V, possibly under regen.
Battery voltage has risen above
35.0V, possibly under regen.
Internal Fault. Return to PGDT if
happening all the time.
Internal Fault. Return to PGDT if
happening all the time.
As above, but can also be caused
by intermittent loss of battery voltage
during use.
Version 1.0.5 - 2021