Panel Ms 200 And Ms 300 Setup Parameters - Kemppi FastMig MS 200 Operating Manual

2.6

Panel MS 200 and MS 300 setup parameters

Normal MIG welding Setup -parameters
Name of parameter
Pre Gas Time
Post Gas Time
Creep Start
Creep Start Level
Start Power
Post Current Time
Arc Voltage
Cable Length
EN
Synergic MIG -welding SETUP -parameters
Name of parameter
Pre Gas Time
Post Gas Time
Creep Start
Creep Start Level
Hot Start Level
Hot Start 2T Time
Crater Fill End Level
Crater Fill Start Level
Crater Fill Time
Wise Fusion On
Wise Fusion Percent
Wise Penetration On
Penetration Level
MiniLog On
14
FastMig MS 200, MS 300
Name on Parameter
display values
PrG 0.0 – 9.9 s
PoG 0.0 – 9.9 s
Cr OFF, on
CrE 10 – 170%
StA -9 ... +9
PoC -9 ... +9
Ard OFF, on
CAb std, 5 – 80m
Name on Parameter
display values
PrG 0.0 – 9.9 s
PoG 0.0 – 9.9 s
Cr OFF, on
CrE 10 – 170%
Hot -50 ... 75%
H2t 0.0 – 9.9 s
CrL 10 – 250%
CrS 10 – 250%
CrT 0.0 – 9.9 s
FUS OFF, on
FUP 10...60%
PE OFF, on
PEn -30 ... +30%
ML on, OFF
Factory
Description
setting
0,0 s Pre gas time in seconds
Aut Post gas time in seconds or automatically
according to welding current (Aut)
OFF Switch creep start on or off.
50% Percentage of wire feed speed:
10% slowed start
100% = no creep start function
170% accelerated start
0 Strength of start pulse
0 Post current
OFF on: Display shows arc voltage
OFF: Display shows pole voltage
std Cable loss is calculated for optimal arc
control and for the Arc Voltage display
Factory
Description
setting
Syn Pre gas time in seconds or automatically
according to synergic welding program
(Syn)
Syn Post gas time in seconds or automatically
according to synergic welding program
(Syn)
OFF Switch creep start on or off.
50% Percentage of wire feed speed:
10% slowed start
100% = no creep start function
170% accelerated start
30% Percentage of welding power:
-50% cold and +75% hot
1.2 s The duration of the hot start in seconds in
2T mode
30% The welding power at the end of the crater
fill stage as a percentage of the welding
power preset value
30% The welding power at the beginning of
the crater fill stage as a percentage of the
welding power preset value
2.0 s The duration of the crater fill stage in
seconds (only in 2T mode)
OFF
Switch Wise Fusion on/off (only in 1-MIG)
25%
Percentage of Wise Fusion (only in 1-MIG)
OFF
Switch Wise Penetration on/off (only in
1-MIG)
0%
Set the arc length where penetration
control begins (only in 1-MIG)
OFF
Switch on/off MiniLog