Setup Parameters - Kemppi MinarcTig Evo 200 Service Manual

Service manual MinarcTig Evo 200

3.4.5. Setup parameters

To enter the setup you have to press back and forward arrows for three seconds:
Press 3 seconds for entering setup
Parameter Explanation
A.
1 TIG slopes to minimum current
0* TIG current at arc stop is 15 % of welding current
b.
1 no load voltage 30 V (VRD function)
0* no load voltage 95 V
C.
1 by 2T the downslope is cut off by short (<0,4 s) action of the torch switch
0* current can be sloped down and up again
d.
3 Minilog + SearcArc
2 4T-LOG + Minilog
1* Minilog
0 4T-LOG
E. Current Level at ignition (with upslope)
5-40% Range
20 % * Factory default
F.
1 Factory settings recall
0* Factory default
h. Pregas time minimum
0.0- 2.0 s Range
0.0 s* Factory default
J. Postgas time minimum
0-10 s Range
1 s* Factory default
L. Pregas time maximum
5-20 s Range
10 s* Factory default
o. Postgas time maximum
15-99 s Range
30 s* Factory default
S. MMA Dynamics adjustment
-3...5 Range
0* Factory default

* (asterix) presents the factory default setting
13
Kemppi Oy
Version 1.1.5. 29.9.2015